Açıklama
Product Data
• In compliance with IEC 62386-101:2014, IEC 62386-102:2014, IEC 62386-207 Ed2.
• Built-in DALI-2 interface, DALI DT6 device
• Match all DALI systems in the market
• AC phase cut dimmer with both DALI and push switch control interface
• 100-240VAC wide input and output voltage,
• 1 DALI address to control 1 channel output, up to 400W
•Input and output with screw terminals, safe and reliable
• Trailing edge dimming, supports resistive loads and capacitive loads
•Innovative minimum brightness setting function
•Single wire push switch input for push dim function
•Great compatibility with universal 8V-230V~ input push switches
• To dim and switch single color dimmable LED lamps, traditional incandescent and halogen lights
•Mini size, easy to be installed into a standard size wall box
• Waterproof grade: IP20
Safety & Warnings
• DO NOT install with power applied to device.
• DO NOT expose the device to moisture.
Operation
Setting DALI Address:
1 DALI addresses for 1 channel output is assigned by DALI Master controller automatically, please refer to user manuals
of compatible DALI Masters for specific operations.
Setting minimum brightness:
Adjust brightness to a level, then press and hold down “Min. Set ” key on the dimmer until the light flashes, once set a minimum brightness, the light can only be dimmable between this minimum brightness and maximum brightness.
The dimming range of this dimmer is 1%-100%, but some load types may flicker when dimmed to 1%, thus a
minimum brightness shall be set higher than 1% to avoid flickering during dimming process.
Delete the minimum brightness:
Adjust the brightness to maximum level, then click “Min. Set” key on the dimmer to delete the minimum brightness, the light will flash to indicate successful reset.
PUSH DIM:
While connected with PUSH switch, click the button to switch ON/OFF lights. Press and hold down the button to
increase/decrease light intensity.
